The Beastgrip Pro is the world's first universal lens adapter and camera rig system for smartphones. It has an adjustable lens mount and spring loaded clamps ensure secure grip and perfect fit with virtually any phone on the market.

Phone compatibility

The Beastgrip Pro is fully compatible with all Apple iPhone, Samsung Galaxy and Google Pixel phones - including dual camera models - and most other phones! To check compatibility with other phone models, you can refer to the specs chart below or contact us.

Beastgrip Pro compatibility specs

Lens mount inserts

The Beastgrip Pro includes lens mount inserts for single and dual camera phones. See below for examples of how to set up the correct insert for your phone.

For the best performance when using external optics, please ensure that you're using the correct rubber insert for your phone and remove any protective case(s).

Instructions for installing the rubber lens mount insert

Instructions for installing the rubber lens mount insert

Mounting your phone

Squeeze the spring-loaded clamp until there is enough room to place your phone between the clamps. 

Attention: to prevent possible damage to your phone, DO NOT force your phone into the clamps.

Instructions for mounting your phone into the Beatsgrip Pro part 2

Place your phone between the clamps, then release the upper clamp to hold your phone firmly in place. Make sure that your phone is positioned flush against the base of the Beastgrip Pro.  

Instructions for mounting your phone into the Beatsgrip Pro part 2

Aligning the lens mount

Release the thumb screws on the base and lens mount to align the lens mount opening with your phone's camera, then re-tighten the screws.

Instructions for aligning the lens mount on the Beastgrip Pro

Adjusting the clamp jaws

Both the upper and lower clamps can be mounted in different configurations with the included hex key to adjust the amount of pressure to hold your phone securely in place. The closer the clamps are, the more pressure there will be. 

Instructions for adjusting the clamp jaws on the Beastgrip Pro

Attaching the cold shoe mount

Place the included cold shoe mount on any one of the four built-in 1/4"-20 mounts, insert the screw and tighten it with the included hex key. Note: mounts are located on the top and bottom of each handle.

Instructions for attaching a cold shoe mount to the Beastgrip Pro

Modifying the body

The Beastgrip Pro can be setup differently, based on your needs. See below for a few common examples. 

Beastgrip Pro configuration objects